-
Embedded Processors for Industrial Applications
-
Companion Power Selection Guide: Blackfin & SHARC Processors
-
Power Regulation and
Supervisory Selection Guide -
Motor and Power Control Brochure (pdf)
-
Explore ADI's Interface
Products Brochure
駆動装置
駆動装置
Drive systems offer the advantage of closing the loop to perform better control of torque currents and in some cases position. This higher performance is required in certain applications and these designs are optimized on power flow, along with efficiency.
Amp
- AD628: High Common-Mode Voltage, Programmable Gain Difference Amplifier»
- AD629: High Common-Mode Voltage Difference Amplifier»
- AD8275: G = 0.2, Level Translation, 16-Bit ADC Driver»
ADC
- AD7262: 1 MSPS, 12-Bit, Simultaneous Sampling SAR ADC with PGA and Four Comparators»
- AD7352: Differential Input, Dual, Simultaneous Sampling, 3 MSPS, 12-Bit SAR ADC»
- AD7356: Differential Input, Dual, Simultaneous Sampling, 5 MSPS, 12-Bit SAR ADC»
Isolated ADC
ADC
- AD7656-1: 250 kSPS, 6-Channel, Simultaneous Sampling, Bipolar, 16-Bit ADC»
- AD7606-6: 6-Channel DAS with 16-Bit, Bipolar, Simultaneous Sampling ADC»
- AD7266: Differential/Single-Ended Input, Dual, Simultaneous Sampling, 2 MSPS, 12-Bit, 3-Channel SAR Analog-to-Digital Converter»
MEMS
- ADIS16220: Programmable Digital Vibration Sensor»
- ADIS16223: Digital Tri-Axial Vibration Sensor»
- ADIS16227: Digital Tri-Axial Vibration Sensor with FFT Analysis and Storage»
Power and Support
- Use ADIsimPower for fast, accurate dc-to-dc power management design»
- View our power management portfolio»
Isolated Gate Driver
- ADuM7234: Isolated Precision Half-Bridge Driver, 4 A Output»
- ADuM6132: Isolated Half-Bridge Driver with Integrated Isolated High-Side Supply»
- ADuM3220: 4 A Dual-Channel Gate Driver»
Isolation
- ADuM1311: Triple-Channel Digital Isolator»
- ADuM1411: Quad-Channel Digital Isolator»
- ADuM2401: Quad-Channel Digital Isolator»
Amp
- AD628: High Common-Mode Voltage Programmable Gain Difference Amplifier»
- AD629: High Common-Mode Voltage
Difference Amplifier» - AD8275: G = 0.2, Level Translation, 16-Bit
ADC Driver»
Digital or Analog Input
- AD977/AD977A: 16-Bit, 100 kSPS, Serial I/O Analog-to-Digital Converter»
- AD7663: 16-Bit, Bipolar, 250 kSPS PulSAR� CMOS ADC»
RS-232/RS-485/CAN Isolated or Nonisolated
- ADM2484E: 5 kV Signal Isolated, ESD Protected, 500 kbps, Full/Half Duplex RS-485 Transceiver»
- ADM2582E: 2.5 kV Signal and Power
Isolated, �15 kV ESD Protected, Full/Half Duplex RS-485 Transceiver (16 Mbps)» - ADM2491E: 5 kV Signal Isolated, High Speed (16 Mbps), ESD Protected, Full/Half Duplex RS-485 Transceiver»
Amp/DAC/ADC
- AD977/AD977: 16-Bit, 100 kSPS, Serial I/O Analog-to-Digital Converter»
- AD7663: 16-Bit, Bipolar, 250 kSPS PulSAR� CMOS ADC»
- AD8221: Precision Instrumentation Amplifier»
- AD629: High Common-Mode Voltage
Difference Amplifier»
Processor
- ADSP-BF506F: Blackfin� Processor with Executable Flash, ADC, and Optimized Peripheral Set for Industrial and General-Purpose Applications»
- ADSP-2148x SHARC� DSP»
DRIVES SYSTEM DIAGRAM
Hover over the blue blocks to view ADI product recommendations. Click a part number to access the product page.
SELECT A PRODUCT
- Isolated/Shunt Modulators
- Non-Isolated/Transformer (Bipolar)
- Non-Isolated/Transformer (Unipolar)
- Supply Side
- Phase
- Low Side
- Sine/Cosine Encoder
- Incline Angle
- Relative Angle/Rate
- MultiAxis/Complex
FEEDBACK & SENSING
Current Sensing
Position Sensing
- Isolated/Shunt Modulators
- Non-Isolated
- Level Shifting
- Supply Side
- Phase
- Vibration
- Command Input
.
Voltage Sensing
Condition Sensing
Analog Input
- Digital Isolators
- Isolated Gate Drivers
ISOLATION
- Fixed Point
- Floating Point
PROCESSING
- Ethernet IEEE 1588
- CAN Controller
- USB Controller
- UART
- Isolated RS-485/422
- Non-Isolated RS-485/422
- Isolated RS-232
- Non-Isolated RS-232
- Isolated USB
COMMUNICATIONS
Embedded Controllers
Physical Layer Devices
RESOURCES & RELATED INFORMATION
